Kommen Sie schneller ans Ziel:

Sound decoupling with wedi Nonstep Plan

If the floor covering to be renovated has slight bumps, wedi Nonstep Plan is inserted. The impact sound insulation panel is made of recycled rubber material and XPS flakes, bonded with polyurethane coated with a special mineral coating. On wedi Nonstep Plan, after full-surface reinforcement with wedi tools, joint reinforcement tape can be directly tiled. Only rough bumps must be filled in advance. Impact sound improvement measure under ceramic floor coverings: 14 dB.

Mount a wedi tools® edge insulation strips all around. Make sure that there are rough unevenness before laying. The cutting can be done simply with a carpet knife.
Tape the joints with masking tape to prevent the formation of sound bridges.
Apply the wedi 320 Tile Adhesive over the entire surface as a contact layer. Insert wedi tools joint reinforcement tape with an overlap of 5 – 6 cm into the tile adhesive and embed it with the trowel. It can then be tiled.
Areas should be sealed, so the joints should be covered with masking tape. Then carry out the joints with wedi tools sealing tape and wedi 520 sealing slurry and coat the Complete. Then, apply wedi 520 waterproofing slurry across the entire surface. Apply wedi tools self-adhesive reinforcement tape 600 mm.

Decoupling and insulating with wedi footfall sound insulation

Dieser Inhalt wird durch YouTube bereitgestellt. Durch Laden dieses Inhaltes stimmen Sie der Übermittlung Ihrer Daten an YouTube / Google zu. Weitere Informationen dazu finden Sie hier: Google-Datenschutz.