Find your route faster:

Linear drainage on timber substrates.

Flush-to-floor shower systems

The flush-to-floor shower elements Fundo Riolito and Fundo Riofino from wedi are also ideally suited for linear drainage on timber substrates. The assembly steps described below, shown in the example of Riolito, are valid for both drain systems.

Cut out the necessary floor piece to install the drain element.
Connection and positioning of the drain body to the pipe. The top edge of the drain flange should be level with the timber floor.
Fill the formwork element with mortar up to the top edge of the drain flange. In the area of the draining, ensure that the bed is fully laid.
Reinstall the cut-out floor pieces.
If necessary, prime the timber surface before bonding the elements
Screw on the drain connection with 4 screws on the Fundo Rear. The screws must be hand-tightened.
Apply wedi 320 tile adhesive evenly to the underside of the Fundo Riolito and bond it to the substructure.
Seal the joints using wedi 610 adhesive and sealant and wedi tools joint reinforcement tape. The wedi Fundo Riolito profile is then installed.
Use the enclosed tile stop bars. They ensure the correct clearance when tiling.
Tile elements.