Find your route faster:

Wall application for wedi building board

The wedi building boards are also ideally suited for use beneath underfloor heating systems. The excellent insulating properties of the building boards prevent heat from escaping into the floor and instead direct it straight into the room. It doesn't matter whether the system is water-based or electric, wedi building boards are suitable for both.

Note for electrical resistance heating

Electric underfloor heating can be installed on already laid and reinforced elements (e.g. wedi building boards, Fundo floor elements, Sanoasa benches, Sanoasa lounger) according to the manufacturer's specifications. Only heaters approved for this area may be used.

Record channels/grooves for the installation of the heating system on the wedi building board.
Building board with heating on the wall
Cut out grooves with the router. The trimming width should be the same as the pipe width, the trimming depth should be at least 3 mm deeper.
Place the pipes in the groove. Fill the pipe ducts with tile adhesive, e.g. wedi 320 tile adhesive.
Apply wedi tools self-adhesive reinforcement tape 600 mm to the entire area.