Find your route faster:

Voltage decoupling with wedi Subliner Flex

Subliner Flex is used for safe decoupling and for stress reduction between ceramic tiles, slabs and natural stone surfaces and the surface in indoor areas. It offers high crack-bridging and is ideally suited for renovations and renovations due to its low structural strength.

Lay out wedi Subliner Flex and cut it with cutter or scissors.
Comb wedi thin-bed mortar (wedi 320) using a notched trowel with 4 or 6 mm teeth on the prepared surface.
Insert wedi Subliner Flex with the printed side facing up butt-to-butt and press it with a rubber roller or wooden board.
Remove any leaking mortar and air pockets. Avoid cross joints.
After the thin-bed mortar has hardened, the coating can be laid.

The wedi building board range

Under the Tile is required
wedi building board
Building board
Wedi building boards XL and XXL
Building board XL and XXL
Vapor building board
Construct building board
PreLine building board