Find your route faster:

Flush-to-floor shower systems

Timeless design and a wide range of design options. The Fundo Riolito Discreto literally crowns the proven Riolito. As a simple attachment element, this clever innovation creates an optically attractive wall drain. The attachment element can be easily extended in all directions. Whether as a seat, storage option or complete front wall, there are no limits to the design ideas with these system components. Design in perfection.

The Riolito Discreto Elements can be pre-assembled at a comfortable working height.
Insert the gray tile stop bars. These are included in the scope of delivery of the Riolito shower element.
Position the Discreto element and apply wedi 610 adhesive sealant sparingly. (Important: Application also on the foam edge!).
Place the Riolito Discreto Element on the channel of the Riolito Shower Element and press it down. The tile stop pieces specify the forward limit/alignment.
Check the correct position (perpendicular to the Bottom of the Riolito Shower Element)
Fasten the Riolito Discreto elements from behind with screws. This means that work can then be continued directly without waiting for the wedi 610 adhesive and sealant to cure.
Once the wedi 610 adhesive sealant is pressed into the interior, it can be easily removed with a utility knife once it has cured.
Apply wedi 610 adhesive and sealant to the back of the metal angle.
Take the later floor tile. Apply them and simulate the subsequent tile adhesive layer, e.g. with a unit of cardboard. Place wedi building board spacers on the floor tile and stick sheet brackets to the front of the Riolito Discreto Elements. Wait until the adhesive has tightened (3 - 4 hours). Mount the Riolito Shower Element according to the Riolito installation instructions.
To maintain the correct and required distance between the floor and wall tiles, re-insert the spacers flush with the outsides, as described above, with the Fold outwards (see Fig. 10).
This also applies to creating a frame from tile profiles, as shown in Figure 12.
Inserting the spacers as described above also applies to creating a frame of tile profiles.
View Side of Cover Select Stainless Steel Surface or Tile. Insert the hanger plates into the holes on the short sides of the Cover so that the hooks are aligned backwards (away from the visible side).
Please check the correct, firm seat and direction again! Once the visible side has been tiled, any corrections can no longer be made.
Place the adjustment template with the hole on the lateral bracket and loosen the screws slightly. Align the suspension so that the template is flush with the wall tile and rests on the floor tile ...
... The equally flush position of the rear edge of the template on the front edge of the suspension ensures the correct perpendicular position. Now use the Allen key to tighten the suspension.
The cover caps (scope of delivery no. 8) must be pressed onto the visible threaded rods.
Finally, the Cover is attached. It clicks into place audibly by a slight pressure on the top edge.

The wedi building board range

Under the Tile is required
wedi building board
Building board
Wedi building boards XL and XXL
Building board XL and XXL
Vapor building board
Construct building board
PreLine building board