Find your route faster:

Sanoasa wellness lounger

wedi Sanoasa loungers stand out due to their distinctive

and unique shapes. They give each wellness area an individual touch, whereby the various forms are designed almost limitlessly and can thus be harmoniously integrated into the entire room concept. On request, all loungers are available with integrated heating (either hot water or electric heating). For all loungers with an electric heater, there are two thermostat options: AEG 900 (flush-mounted thermostat) and AEG 300 (rail mounting).

Apply a contact layer to the floor surface of the lounger with wedi 320 tile adhesive over the entire surface and then comb on the adhesive (alternatively, apply wedi 610 adhesive and sealant).
Position the lounger and press it into the adhesive bed.
Apply wedi tools joint reinforcement tape in the transition areas of the lounger to the ground and embed it with wedi 320 tile adhesive.
Bonding of the lounger to the floor surface in the same way as for bonding the one piece lounger (see 1). Next, bond the reclining surface to the base using wedi 320 tile adhesive (alternatively, use wedi 610 adhesive and sealant). To do this, apply the adhesive over the entire surface as a contact layer and then comb on the adhesive.
Next, reinforce the transitions between the base and the reclining surface using wedi 320 tile adhesive and wedi Tools reinforcing tape.

Special features Sanoasa wellness lounger no. 4: Different Surfaces

Plaster or tile the base structure up to the marked line, or finish it with a similar surface treatment.
Apply wedi 320 Tile Adhesive or wedi 610 Adhesive and Sealant to the adhesive surfaces.
Press the lying surface into the adhesive.
Tile the reclining surface and seamlessly connect it to the base structure.

Special features Sanoasa wellness lounger no. 4: Uniform Surfaces

Glue the lying surface and the base structure together with wedi 320 tile adhesive or alternatively with wedi 610 adhesive and sealant.
Press the lying surface into the adhesive.